When you want to digitalize vinyl, and i'm sure that you want, the main problem is to interface phono and line level : you can use your mixer preamp but ART is giving us two news and better solutions :
The DJ PRE II acts as an interface between your turntable and your sound card. The analog input capacitance can be switched between 100pF and 200pF to optimize your phono cartridge response. A switchable low cut filter removes turntable rumble.
The front gain trim control and signal/clip LED allow you to optimize the preamp's gain for a wide range of input sources. The built-in low noise phono preamp circuitry conforms to the RIAA standard. The line output jacks are low impedance and can be used with any sound card.
The USB Phono Plus is a USB audio interface with a standalone Phono preamplifier.
It acts as an interface between your computer and a wide variety of analog and digital sources. The analog inputs are switchable between Phono and Line level signals and a low cut filter removes rumble and wind noise while leaving the audio pristine. The front gain trim control and signal/clip LED allow you to optimize the A/D for a wide range of input sources. The front panel USB monitor/headphone jack and the optical output on the rear panel can monitor audio output from your computer. The built-in low noise Phono preamp circuit is highly accurate and precisely conforms to the RIAA standard. The Line Output jacks are always connected to the input preamps signal for source monitoring.
Housed in an all aluminum black anodized case, the USB Phono Plus can be powered by either an external power source or directly off the USB port so remote recording is a snap. Optical TOSLINK inputs and outputs as well as S/PDIF inputs let you use the USB Phono Plus as a digital audio to USB interface as well.
The DJ PRE II acts as an interface between your turntable and your sound card. The analog input capacitance can be switched between 100pF and 200pF to optimize your phono cartridge response. A switchable low cut filter removes turntable rumble.
The front gain trim control and signal/clip LED allow you to optimize the preamp's gain for a wide range of input sources. The built-in low noise phono preamp circuitry conforms to the RIAA standard. The line output jacks are low impedance and can be used with any sound card.
The USB Phono Plus is a USB audio interface with a standalone Phono preamplifier.
It acts as an interface between your computer and a wide variety of analog and digital sources. The analog inputs are switchable between Phono and Line level signals and a low cut filter removes rumble and wind noise while leaving the audio pristine. The front gain trim control and signal/clip LED allow you to optimize the A/D for a wide range of input sources. The front panel USB monitor/headphone jack and the optical output on the rear panel can monitor audio output from your computer. The built-in low noise Phono preamp circuit is highly accurate and precisely conforms to the RIAA standard. The Line Output jacks are always connected to the input preamps signal for source monitoring.
Housed in an all aluminum black anodized case, the USB Phono Plus can be powered by either an external power source or directly off the USB port so remote recording is a snap. Optical TOSLINK inputs and outputs as well as S/PDIF inputs let you use the USB Phono Plus as a digital audio to USB interface as well.
Permalink : : Visit module main site :
1 Comments:
I've been needing/looking for something like this for quite some time... and now, it's so cheap!!
Post a Comment
<< Home